[NLRS] 900 AMP UPDATE

[Scanner.Kleindl@VerizonWireless.com]

	This is for the HIGH and LOW power amps.  TNX to Eric for asking me
a question.  Inside both units there is a YELLOW wire feeding one side of
the amp. on the high power its daisy chains to the other amp.  This is what
you can do.  Cut the wire and install a relay to turn the biasing ON and OFF
( it requires a high to turn on the base biasing )  This should cut down the
idle current and make the amp run cooler in standby ( from 2 amps to 400 ma
)  Last, if not hook up it will not put out power.  Good luck.  73's Dave
N0KP