[NLRS] Tnx to all on MOSFET data

[W0ZQ at aol.com]

Thanks to all who responded to my question  regarding the dual gate MOSFET 
and its orientation.  The problem was that  the Drain had the long pin (OK), but 
none of the other three pins were cut like  that shown in the specification 
sheet, they are all identical, so  it brings into question whether the pin out 
drawing is viewed from the  top, or from the bottom ..... the difference would 
reverse Gate-2 and  Source.   I went with the consensus that the pin out 
drawing is viewed  from the top and that seemed to work.   Again, thanks to  all.

73, Jon
W0ZQ