[NJARC] Knight KX-60 Amplifier

Sat Jun 11 23:32:26 EDT 2016

Chuck -

Good news. As I said, just about anything would work in that circuit, so, do
not worry about the numbers, HI. 73 - Mike 

Mike B. Feher, N4FS
89 Arnold Blvd.
Howell, NJ, 07731
732-886-5960 

-----Original Message-----
From: Chuck [mailto:cpaci1 at verizon.net] 
Sent: Saturday, June 11, 2016 11:24 PM
To: Mike Feher; 'Rich'; njarc at mailman.qth.net; 'Al Klase'
Subject: Re: [NJARC] Knight KX-60 Amplifier

Hi Mike,
The transistors Al gave me did work! Thank you Al!!!
Except I can't tell you what they are because the print is worn of them and
I cannot read the numbers - ugh --- lol...

-----Original Message----- 
From: Mike Feher
Sent: Friday, June 10, 2016 11:48 PM
To: 'Chuck' ; 'Rich' ; njarc at mailman.qth.net ; 'Al Klase'
Subject: RE: [NJARC] Knight KX-60 Amplifier

I do not believe that Rich read the earlier emails and saw the schematic of
where these are used. So, I did not comment on his post. Let us know Chuck.
73 - Mike

Mike B. Feher, N4FS
89 Arnold Blvd.
Howell, NJ, 07731
732-886-5960

-----Original Message-----
From: Chuck [mailto:cpaci1 at verizon.net]
Sent: Friday, June 10, 2016 11:45 PM
To: Rich; Mike Feher; njarc at mailman.qth.net; Al Klase
Subject: Re: [NJARC] Knight KX-60 Amplifier

Hi Rich,
I think I got the right type from Al tonight at the meeting.
I'm going to give that a try tomorrow.
I'll let everyone know if it works...

Thanks for the heads-up Rich!

Chuck

-----Original Message-----
From: Rich
Sent: Friday, June 10, 2016 9:04 PM
To: Mike Feher ; 'Chuck' ; njarc at mailman.qth.net ; Al Klase
Subject: Re: [NJARC] Knight KX-60 Amplifier

Hi guys,

I use to repair those old transistor car radios and just wanted to say that
as you know most used Ge PNP power transistors. Substituting a silicon PNP
will usually result in cross-over distortion due to the difference in the
base-emitter bias voltage.  Give it a try, it will not cause any damage,
just a good possibility of distortion.

Good Luck with it,
Rich L.

--------------------------------------------------
From: "Al Klase" <ark at ar88.net>
Sent: Friday, June 10, 2016 1:34 PM
To: "Mike Feher" <n4fs at eozinc.com>; "'Chuck'" <cpaci1 at verizon.net>;
<njarc at mailman.qth.net>
Subject: Re: [NJARC] Knight KX-60 Amplifier

> Just remember
> Reply = Poster
> Reply All = Everyone
>
> _________________________________________________________
> Chuck,
>
> Mike's analysis has been spot on.  In this particular circuit, silicon
> should work just fine, that's not always the case.
>
> In the mean time I dug through my Germanium power box, and will bring
> some PNP TO-3 along to the meeting.
>
> Mike, can you take a SWAG at the required HFE (gain).  I'm thing 10
> would be sufficient.
>
> Al
>
> Al Klase - N3FRQ
> Jersey City, NJ
> http://www.skywaves.ar88.net/
>
> On 6/10/2016 12:35 PM, Mike Feher wrote:
>> Chuck -
>>
>> Even without going downstairs, which I try to avoid nowadays, I found
>> some 2N4398s by Motorola that are NOS. These are TO-3 PNPs but
>> silicon. I am sure they will work just fine in that circuit. You can
>> pick them up, or, I can mail them to you. Here is the data sheet. 73
>> - Mike
>>
>> http://www.nteinc.com/specs/original/2N4398_99.pdf
>>
>> Mike B. Feher, N4FS
>> 89 Arnold Blvd.
>> Howell, NJ, 07731
>> 732-886-5960
>>
>>
>> -----Original Message-----
>> From: Chuck [mailto:cpaci1 at verizon.net]
>> Sent: Friday, June 10, 2016 11:09 AM
>> To: Mike Feher; 'Al Klase'; njarc at mailman.qth.net
>> Subject: Re: [NJARC] Knight KX-60 Amplifier
>>
>> Thank you Mike.
>> You have been a great help!
>> And -- I would be more than happy to pay for those transistors.
>> See you tonight at the meeting.
>> Thanks again!!!!!!!
>> Chuck
>>
>> -----Original Message-----
>> From: Mike Feher
>> Sent: Friday, June 10, 2016 10:57 AM
>> To: 'Chuck' ; 'Al Klase' ; njarc at mailman.qth.net
>> Subject: RE: [NJARC] Knight KX-60 Amplifier
>>
>> If I find a couple you can have them. I just have to go downstairs
>> and check, but, I know I have them. They are really not that critical
>> as the voltages on all three junctions is essentially the same. Your
>> only real criteria is that they be PNP in a TO-3 style package. Even
>> NPNs would work, but would require some circuit topology of the PS to
>> change. Even silicon will work, giving you a few tenths of a volt
>> less out. Will let you know as I have thousands. 73 - Mike
>>
>> Mike B. Feher, N4FS
>> 89 Arnold Blvd.
>> Howell, NJ, 07731
>> 732-886-5960
>>
>>
>> -----Original Message-----
>> From: Chuck [mailto:cpaci1 at verizon.net]
>> Sent: Friday, June 10, 2016 10:09 AM
>> To: Mike Feher; 'Al Klase'; njarc at mailman.qth.net
>> Subject: Re: [NJARC] Knight KX-60 Amplifier
>>
>> Hi Mike,
>> That sounds very plausible.
>> My experience with solid state is fairly limited and this power
>> supply circuit design is new to me.
>> If you do find a couple transistors that will work, I will buy them
>> from you.
>>
>> Thanks Mike...
>> Chuck
>>
>> -----Original Message-----
>> From: Mike Feher
>> Sent: Friday, June 10, 2016 7:16 AM
>> To: 'Chuck' ; 'Al Klase' ; njarc at mailman.qth.net
>> Subject: RE: [NJARC] Knight KX-60 Amplifier
>>
>> Chuck -
>>
>> I believe on this case the transistors are acting as C multipliers
>> using the Miller effect. The diodes are doing the rectification. I
>> have lots of PNP power Ge transistors. 73 - Mike
>>
>> Mike B. Feher, N4FS
>> 89 Arnold Blvd.
>> Howell, NJ, 07731
>> 732-886-5960
>>
>> -----Original Message-----
>> From: NJARC [mailto:njarc-bounces at mailman.qth.net] On Behalf Of Chuck
>> Sent: Friday, June 10, 2016 4:40 AM
>> To: Al Klase; njarc at mailman.qth.net
>> Subject: Re: [NJARC] Knight KX-60 Amplifier
>>
>> Just remember
>> Reply = Poster
>> Reply All = Everyone
>>
>> _________________________________________________________
>>
>
> ______________________________________________________________
> NJARC mailing list
> Home: http://mailman.qth.net/mailman/listinfo/njarc
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:NJARC at mailman.qth.net
>
> This list hosted by: http://www.qsl.net Please help support this email
> list: http://www.qsl.net/donate.html
>