[NJARC] DIY Motor Capacitor Meter

[Matt Reynolds]

All,

Saw this in the Jameco newsletter.   It's instructions to build a jig to test motor start capacitors.


I have not tested it, nor do I accept any responsibility should you decide you want to, but I thought it might be of interest to you folks:


http://www.jameco.com/Jameco/workshop/JamecoBuilds/handyman-motor-capacitor-meter-electronics-project.html?CID=NEWSLETTER&trk_msg=05662GMJ42G4L57RU7FEO50G54&trk_contact=VAQR8QNK1ID40J7HJGA8K9E29S&utm_source=Listrak&utm_medium=Email&utm_term=Handyman+Motor+Capacitor+Meter&utm_campaign=Newsletter&utm_content=Newsletter

Handyman Motor Capacitor Meter<http://www.jameco.com/Jameco/workshop/JamecoBuilds/handyman-motor-capacitor-meter-electronics-project.html?CID=NEWSLETTER&trk_msg=05662GMJ42G4L57RU7FEO50G54&trk_contact=VAQR8QNK1ID40J7HJGA8K9E29S&utm_source=Listrak&utm_medium=Email&utm_term=Handyman+Motor+Capacitor+Meter&utm_campaign=Newsletter&utm_content=Newsletter>
www.jameco.com
This electronics project enables you to test motor-run capacitors on appliances even when there is no cap meter at hand.


Regards,

Matt Reynolds


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/mailman/private/njarc/attachments/20160830/8a9fa95a/attachment-0001.html>