[NJARC] Replacing a tapped volume control?

[David Sica]

Schematic: http://www.njarc.org/images/tapped_pot.jpg



Sica Productions
732-382-0618
973-873-6347



On Mon, Nov 3, 2014 at 9:38 AM, Al Klase <ark at ar88.net> wrote:

> Just remember
> Reply = Poster
> Reply All = Everyone
>
> _________________________________________________________
> Dave,
>
> Can you point us to a schematic?
>
> Al
>
> Al Klase – N3FRQ
> Jersey City, NJ
> http://www.skywaves.ar88.net/
>
> On 11/3/2014 8:56 AM, David Sica wrote:
>
>> Just remember
>> Reply = Poster
>> Reply All = Everyone
>>
>> _________________________________________________________
>>
>> I may have to replace a tapped volume control. Haven't had to do that
>> before. Looks like the AGC is taken from the fixed tap.  Any advice on
>> substituting a standard control?  My instinct would be to bridge the pot
>> with a couple of resistors.
>>
>> Thanks,
>> -- Dave
>> ______________________________________________________________
>> NJARC mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/njarc
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:NJARC at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>
> ______________________________________________________________
> NJARC mailing list
> Home: http://mailman.qth.net/mailman/listinfo/njarc
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:NJARC at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>