[NJARC] Need coil-in-can...wire gauge = 40

[sgt88 at atlanticbb.net]

"Right church, wrong pew?"...you may have to move the decimal..my data shows 
40 Ga copper @ 1049 ohms per 1000 feet.

On Sun, 21 Jul 2013 18:51:55 -0700 (PDT)
  Pete O <stateasylum at yahoo.com> wrote:
>  30 inches of #40 wire will measure 26.75 ohms
>
>  Pete O
>
>
>  ________________________________
>  From: "sgt88 at atlanticbb.net" <sgt88 at atlanticbb.net>
>  To: njarc at mailman.qth.net
>  Sent: Sunday, July 21, 2013 4:37 PM
>  Subject: Re: [NJARC] Need coil-in-can...wire gauge = 40
>
>
>  Just remember
>  Reply = Poster
>  Reply All = Everyone
>
>  _________________________________________________________
>  Measured the wire resistance...I need 2.7 ohms on 30 inches = wire gauge 40
>  = 0.003 inch bare wire diameter...
>
>  ...need insulation on it, naturally...
>
>  Tnx,
>  Steve T.
>  On Sun, 21 Jul 2013 16:02:50 -0400
>    <sgt88 at atlanticbb.net> wrote:
>>   Got an open "B dectector coil" - #36842 - in my Grunow 1297 Teledial...12W chassis...simply two coils on post...
>>
>>   Might be challenging to find a replacement...suggestions welcome.
>>
>>   Option is to wind a good coil...I need about 30 inches of "very fine" wire...the smallest diameter I've seen...anybody have 'something' that I can take off the wire...and use it for winding my coil?
>>
>>   Tnx,
>>   Steve T.
>  ______________________________________________________________
>  NJARC mailing list
>  Home: http://mailman.qth.net/mailman/listinfo/njarc
>  Help: http://mailman.qth.net/mmfaq.htm
>  Post: mailto:NJARC at mailman.qth.net
>
>  This list hosted by: http://www.qsl.net
>  Please help support this email list: http://www.qsl.net/donate.html