[NJARC] Need coil-in-can...wire gauge = 40

[Jim Whartenby]

Send your address and I'll get some in the mail to you tomorrow.
Jim



________________________________
 From: "sgt88 at atlanticbb.net" <sgt88 at atlanticbb.net>
To: njarc at mailman.qth.net 
Sent: Sunday, July 21, 2013 3:37 PM
Subject: Re: [NJARC] Need coil-in-can...wire gauge = 40
 

Just remember
Reply = Poster
Reply All = Everyone

_________________________________________________________
Measured the wire resistance...I need 2.7 ohms on 30 inches = wire gauge 40 
= 0.003 inch bare wire diameter...

...need insulation on it, naturally...

Tnx,
Steve T.

On Sun, 21 Jul 2013 16:02:50 -0400
  <sgt88 at atlanticbb.net> wrote:
>  Got an open "B dectector coil" - #36842 - in my Grunow 1297 Teledial...12W chassis...simply two coils on post...
>
>  Might be challenging to find a replacement...suggestions welcome.
>
>  Option is to wind a good coil...I need about 30 inches of "very fine" wire...the smallest diameter I've seen...anybody have 'something' that I can take off the wire...and use it for winding my coil?
>
>  Tnx,
>  Steve T.
______________________________________________________________
NJARC mailing list
Home: http://mailman.qth.net/mailman/listinfo/njarc
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:NJARC at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html