[NJARC] 3RP1 CR tube/Heathkit HO-10 Monitor Scope

Martin Friedman radiomf at comcast.net
Wed Aug 12 14:36:26 EDT 2009


YES!

-----Original Message-----
From: njarc-bounces at mailman.qth.net [mailto:njarc-bounces at mailman.qth.net]
On Behalf Of Scott Roberts
Sent: Wednesday, August 12, 2009 1:23 PM
To: NJARC Radio Club
Subject: [NJARC] 3RP1 CR tube/Heathkit HO-10 Monitor Scope

Just remember 
Reply = Poster
Reply All = Everyone

_________________________________________________________
Wow... Long Subject line...

Anyway, Simple question: First(as usual) the backstory:

I purchased the HO-10 scope with a couple known problems, so I decided to
follow advice from a guy who works on them and not only recap, but
re-resistor the whole item. No problem, simple stuff. However, in so doing,
when I went to remove the CRT tube (3RP1) the base cap pulled off the wires!
It was held very tightly by the socket, and literally pulled off the end:
the adhesive had given up the ghost, and they pulled free of the solder, or
the very ends of the wires came off.

So now I have an unkeyed tube with a bunch of good condition wires, and a
cap to refit.

Looking at the schematic, would it be correct to assume that the only two
wires I could read continuity between would be the heater connections? I
looked over the schematic and found pins 5 & 11 were not used by the tube
itself, and I determined where the gaps between wires were spaced to go to
the pins on either side. I then looked at the line burned into the screen,
and determined orientation, and checked alignment with the cap. It appeared
to be correct, and my thought was that I could confirm by checking
continuity through the heater, as it would be the only place I would find
it. I assembled the cap to the tube after cleaning, fluxing & tinning the
leads, just have to find my Duco cement to glue the base.

Simply put, is my above assumption correct?


Thanks!
Scott
______________________________________________________________
NJARC mailing list
Home: http://mailman.qth.net/mailman/listinfo/njarc
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:NJARC at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 8.5.392 / Virus Database: 270.13.52/2298 - Release Date: 08/12/09
06:09:00



More information about the NJARC mailing list