[NJARC] Beverly 2088 = US RAdio chassis 1007

[john ruccolo]

Hi Ed,

Also, carefully check the pins on that 46 (and all
those "big pin" tubes) for oxidation. Sometimes a
light wire brushing is enough to clean them and
restore operation.


Regards,

John

--- Edward Otte <edotte at optonline.net> wrote:

> Visit our web site - See http://www.njarc.org
> _______________________________________________
> OK no problem. I understand the club has caps too is
> that correct? The tube
> I need is a 46, and it is $24 online.
> 
> Ed
> 
> -----Original Message-----
> From: njarc-bounces at mailman.qth.net
> [mailto:njarc-bounces at mailman.qth.net]
> On Behalf Of Harry Klancer
> Sent: Friday, March 23, 2007 9:25 AM
> To: New Jersey Antique Radio Club
> Subject: Re: [NJARC] Beverly 2088 = US RAdio chassis
> 1007
> 
> Visit our web site - See http://www.njarc.org
> _______________________________________________
> Edward,
> 
> Before you order any tubes, check with Gary D'Amico
> to see whether the
> club has them. If so, it's a lot cheaper.
> 
> Look him up under "Club Programs"
> 
>                                            Harry K
> 
> Edward Otte wrote:
> > Visit our web site - See http://www.njarc.org
> > _______________________________________________
> > Aaron and others,
> >
> > Well so far, all the tubes were check and one came
> up completely dead and
> > one weak. I have a replacement for the weak one
> and I am ordering the dead
> > one. The chassis has been cleaned and I am
> starting the complete buzz out.
> 
> >
> > The speakers (there are two) were in the worse
> shape of the entire radio.
> I
> > bought it with the speakers detached and lying at
> the bottom of the
> cabinet,
> > because the pressboard had cracked and broke into
> four pieces. There were
> a
> > few minor cracks and one good tear. The speakers
> have been repaired with
> > some rubber cement and one patch with rubber
> cement. I took some
> > measurements and my minor woodworking skills were
> employed to create a new
> > backboard for the speaker mounting. I am staining
> it the same color as the
> > rest of the cabinet today and the mounting of the
> speakers will be
> > completed. I was a little worried about those
> speakers because the field
> > coils measured so high but the schematic that I
> now have tells me it is
> OK. 
> >
> > Today I order wire and capacitors also. Some wires
> are open and some caps
> > shorted. 
> >
> > Edward Otte
> >
> > Keep us updated on your progress.
> >
> > Aaron
> >
> > Edward Otte wrote:
> >
> >   
> >> Visit our web site - See http://www.njarc.org
> >> _______________________________________________
> >> Joe,
> >>
> >> First of all I want to say I appreciate
> everyone's help that has been
> >> offered here. My little problem here has offered
> me the opportunity to
> >>     
> > study
> >   
> >> a bit and learn a bit and I am grateful for what
> has been shared with me
> so
> >> far. And allow me to say I have already learned a
> load. 
> >>
> >> So the work progresses!
> >>
> >>
> >>  
> >>
> >>     
> >
> >
> > _______________________________________________
> > NJARC mailing list
> > NJARC at mailman.qth.net
> > http://mailman.qth.net/mailman/listinfo/njarc
> >
> > _______________________________________________
> > NJARC mailing list
> > NJARC at mailman.qth.net
> > http://mailman.qth.net/mailman/listinfo/njarc
> >
> >
> >   
> 
> 
> _______________________________________________
> NJARC mailing list
> NJARC at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/njarc
> 
> _______________________________________________
> NJARC mailing list
> NJARC at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/njarc
> 



 
____________________________________________________________________________________
Now that's room service!  Choose from over 150,000 hotels
in 45,000 destinations on Yahoo! Travel to find your fit.
http://farechase.yahoo.com/promo-generic-14795097