Bill,

Thank you for the feedback and suggestions.

Tyler Gardner
KI7ODK

On Oct 23, 2026, at 5:04 PM, William Curtice <[email protected]> wrote:


Tyler et al.....

Two suggestions:

I purchased a Tuf-Tug model TTWG-500 BSEN, dated 2002, for my use at DARA, that was made for use with 5/16" cable; the DARA cable is 3/8".   

The 5/16" Tuf-Tug worked for me at DARA, but was a bit overly sensitive (locked up too easily). I offer that to you as a freebie if you want it; will ship from WA State.  

DARA may already have a fall arrestor for the tower that you can use; you might check with them if you have not done so already.

Otherwise, the 3/8" model you propose to buy sounds ideal.  

My opinion: Use of a fall arrestor is highly recommended!  I believe it is possible to climb safely without it (using multiple positioning lanyards and attach claws), but using the fall arrestor on the DARA tower makes the climb and descent SO much easier ...... and faster.  The DARA tower structural design makes for a difficult climb; I found it MUCH more difficult than climbing ROHN 25/45. 

Best to All

Bill

Bill Curtice WA8APB
39501 N Hardesty Ln
Elk, WA 99009
937-287-0871









On Fri, Oct 23, 2026, 9:33 AM Tyler Gardner via MVMA <[email protected]> wrote:
MVMA,

While working at DARA this morning, Chuck and I discussed the need for a wire/cable fall arrestor to climb the tower. MVMA has funds that could be used to purchase this safety device for the club/group.

Therefore, I motion to purchase a wire/cable fall arrestor for MVMA.


If others have suggestions for suppliers and/or specific fall arrestors to consider, please share. I will readily admit that I am not very familiar with this equipment.

Thanks,

Tyler Gardner
KI7ODK




_______________________________________________
MVMA mailing list
Home: http://mailman.qth.net/mailman/listinfo/mvma
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html