[MRCG] Clatternet

[boatanchor at martasystems.com]

Thanks for attention to line lengths.. it wasn't a problem with the 
Kleinschmidt as it has auto-cr with lf, but the Model 32 ASR I used last 
night just piles up at the end of line. No manual cr release button, either 
! Another cost-reduction measure no doubt.

The interfering signal captures the CV-278 discriminator when signal is 
nearly equal to our net, so during those periods we lose print.

BTW, on the MD-203 FSK modulator, I have disconnected the crystal ovens 
(which helps) but it's internal LOs still drift around. I check its output 
and adjust the TX input LO (a synthesizer) before transmitting to try to 
remain close to net freq. Wonder how it performed in the field when it was 
new?

john wb6azp


-----Original Message----- 
From: Mark J. Blair
Sent: Monday, November 17, 2014 03:12
To: MRCG Mailing List List
Subject: Re: [MRCG] Clatternet

I had auto-CR set at 72 columns in FLDIGI. I just changed it to 70, so 
hopefully that will help until I get my GRC-26D modems up and running.

-- 
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/

______________________________________________________________
MRCG mailing list
Home: http://mailman.qth.net/mailman/listinfo/mrcg
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:MRCG at mailman.qth.net

Website: http://www.mrcgwest.org

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html