Ray and "Milrad" --

Thanks for the info.

My initial goal is to provide a field solution for my BC-221.  It now has a 110 VAC power supply, and I'd like to convert it to 12 V DC.

I need 6.3 V AC/DC and 150V @ 20 mA.      A single battery with the DC-DC converter should work.

I use LiFePO4 batteries for POTA (Parks On The Air) activities and can run my IC-7300 at 100W for 2 to 3 hours (which is why I typically run it at 50W).    Since the 211 will only be on intermittently, a single battery should easily last for 2 days.    

I'd generate some heat for the filament dropping resistor, but that doesn't matter.

73 Mark K3MSB





On Fri, Sep 12, 2025 at 9:21 AM Ray Fantini <RAFANTINI@salisbury.edu> wrote:

Just finished a DAG radio direction finder using this same converter. Its providing 90 volts and replacing a B battery. Built a small box that takes the output of a twelve volt SLA Battery and provides 1.5 and 90 volts for the direction finder. Found that the inverter was fairly quiet but is almost completely lacking any output filtering. It also produced noise on the input buss to the battery but keeping everything in a meatal box and short it was not an issue. Regulation was ok but did notice there are some points where the PWM system on the board will produce weird noise at some settings. Think the little inverter is good for low power things like replacing B Batteries but would not trust it for things like 225 B+ supplies in a big radio.

 

Ray F/KA3EKH

 

 

From: mrca-bounces@mailman.qth.net <mrca-bounces@mailman.qth.net> On Behalf Of MilRad via MRCA
Sent: Thursday, September 11, 2025 9:30 PM
To: Mark K3MSB <mark.k3msb@gmail.com>; ARC5 <arc5@mailman.qth.net>; List Milsurplus <milsurplus@mailman.qth.net>; Military Radio Collectors Association (mrca@mailman.qth.net) <mrca@mailman.qth.net>
Subject: Re: [MRCA] DC-DC Up Converter

 

 

I have had good luck with this one.

 

On 09/11/2025 7:39 PM EDT Mark K3MSB <mark.k3msb@gmail.com> wrote:

 

 

Hi Folks

 

A while back (perhaps a few weeks)  there was a thread on DC to DC up converters in which there was one particular unit that quite a few people liked.

 

I thought I saved that info but didn't.  If anyone has the info, please forward.

 

Thanks

 

Mark K3MSB