Thanks Gentlemen

I agree, a major milling job... at the least. I just removed the large feet and am trying to make it look somewhat MIL. If I use a base-plate a bit wider than the original, the mounts I have may be ok if I use a fender washer so as to clear the outer ring of the pin assy. I also may have found someone who can, at least, shear aluminum.

Jeep K3HVG

On 09/01/2024 11:40 AM EDT jphutch60bj <[email protected]> wrote:

Why do that?

I use 1" rubber bumpers as feet, slipped over the pins.

There are alternatives... }

On 9/1/2024 9:10 AM, Doran Platt via MRCA wrote:
Has anyone successfully removed the pins from the bottom of the receiver cabinet? I have made several ersatz mounts in the past but the smaller size Barrymounts are now hard to find. It appears that the pin assy may be welded to the secondary part of the receiver case? Any info?

Jeep K3HVG
______________________________________________________________
MRCA mailing list
Home: http://mailman.qth.net/mailman/listinfo/mrca
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
MRCA mailing list
Home: http://mailman.qth.net/mailman/listinfo/mrca
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html