[MRCA] ATA ARA RX Alignment Question

[Mark K3MSB]

I'm thinking of aligning my  500 to 1500 Kc receiver.

Page 41 of the manual says to raise the protruding bakelite rods (of the 3
IF transformers) until they snap into the up position.

Delicately playing with one of them, it seems rather fragile, and I have to
use a small pliers to move it -- I'm not sure what tool they used back then.

It didn't want to move either way, and I was leery of giving it a good
twist for obvious reasons.  The other two seem just as delicate.

The radio plays but it a bit lethargic -- i was thinking of just doing an
alignment with the rods as they were (although the manual frown on that)

Comment from anyone that's done an alignment on this RX before?

73 Mark K3MSB
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/mrca/attachments/20250817/89b3391f/attachment.html>