[MRCA] Parts Box Inverter

[scottjohnson1 at cox.net]

Ray-

I would endorse using old 400 Hz transformers, I build a couple of inverters
with them and they work amazingly well, plus it vindicated me- I caught a
lot of crap for years from people questioning why I would save them.  The
also make great modulation transformers, if you can find  the proper ratio
and power level.  BTW, I have run them as high as 2500 Hz, the efficiency
usually peaks well north of 400 Hz when driving with a square wave.  

 

Scott

 

From: mrca-bounces at mailman.qth.net <mrca-bounces at mailman.qth.net> On Behalf
Of Ray Fantini
Sent: Tuesday, April 2, 2024 08:12
To: milsurplus at mailman.qth.net; MMRCG at groups.io; MRCA at mailman.qth.net
Subject: [MRCA] Parts Box Inverter

 

I wanted to throw together something that would provide between 90 to 135
volts for operating radios in the field along with using junk from around
the shop and not buy anything. 

Thought about doing a high frequency inverter but with all the issues with
RFI and having to use high frequency transformers decided to go with low
frequency. The power supply may be bigger and not suited for a small radio
but with the WS, TBX or GRC stuff I am playing around with don't care about
size and weight.

The inverter is built around a 555 developing a square wave output that is
directly coupled to a Mosfet driving a power transformer in reverse. The 10
K pot allows you to adjust the pulse width of the oscillator and affects the
output voltage. Combinations of the 0.33 and 12 K resistor set the frequency
of the oscillator and figure its running around seventy or eighty Hz.

The RFP50N05 50V 50A 120A Pulsed N-Channel Power Mosfets is from an old UPS
system and is magic, unlike a transistor they have almost no internal
resistance when turned on and develop almost no heat.

The transformer is a 36 volt and although it is not happy about being driven
by a square wave it works and provided a good range of output. Thru trial
and error found this one to be best. Transformers work both ways so you can
use the primary as the secondary and they don't know the difference. The
trick is to not exceed the insulation value.  Cheap Radio Shack transformers
tended to get hot or buzz.

The output side of the transformer, the old primary feeds a full wave bridge
and conventional filter network.

Couple things that I would have liked to do different is maybe use a 400
cycle transformer because that way can use a smaller transformer and
filters. The Mosfet I am using runs all day long under load and never gets
warm so will keep it simple for now.

 

Ray F/KA3EKH

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/mrca/attachments/20240402/81d4d57f/attachment.html>