[MRCA] BC-659 Terminal Box use. - correction

[mkdorney at aol.com]

The type of Coax needed is RG-11, not RG-8
 
Mark
WW2RDO
 
In a message dated 1/24/2018 8:18:01 PM Eastern Standard Time, mrca at mailman.qth.net writes:

 
Here's a tidbit of news about the terminal boxes used on the BC-659 radio to allow for coaxial cable use.  The terminal boxes don't provide for an antenna match for the whip antenna.  You have to use about 10 feet RG8 coax ( about a half wave length) to allow the Terminal Box TM-218 to be used.  You need this length to get the antenna feed line impedance close enough to 50 Ohms to allow the radio to be tuned.  Using a 50 ohm dummy load also won't work, because their is no matching transformer on the radio itself, only a changeover strap.  Antenna tuning, therefore has to be done after final installation on any vehicle if using a TM-218 terminal box with the BC-659.


Mark
WW2RDO
______________________________________________________________
MRCA mailing list
Home: http://mailman.qth.net/mailman/listinfo/mrca
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:MRCA at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/mrca/attachments/20180125/ce037928/attachment-0001.html>