[MRCA] tcs dual dynamotor lubing

[JEFF CICCONE]

folks

i am trying to lube the bearings of the transmitter dynamotor. the one end went fine. however i am trying to remove the fan at the other end.  2 allen set screws tighten against the shaft i was able to loosen one however the second one i could not loosen so it looks like i will need to drill it out. do i need a little gear puller to remove the fan?  once that gets pulled off inassume i can remove the 2 screws that hold the cover plate exposing the bearing?


any advice would be appreciated

thanks jeff kg2bz
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/mrca/attachments/20180115/3831fce2/attachment-0001.html>