[MRCA] Component Tester Drilling Template

[ROBERT FORTE]

AND I BOUGHT THIS TOO ( ALSO A MEMBER OF NJARC).  USED 4-3/4 " WOOD SCREWS  WITH NON CONDUCTING  SPACERS UNDERNEATH, MOUNTED ON A 4'' INCH WIDE POPLAR BOARD FROM THE JUNK BIN AT HOME D. FOR THE BATTERY BOX, THE #4 OR #2  1/2" WOOD SCREW WORKS WELL. ONLY ISSUE WAS THAT THE DISPLAY PANEL WS LOOSE FROM ITS MOUNTING BRACKET; VERY CAREFULLY, SECURED SAME WITH A DAB OF CRAZY GLUE. BE CAREFUL HERE. WILL AFFECT DISPLAY IF YOU ARE SLOPPY. NOW THAT I HAVE THREE, WILL DONATE ONE TO THE CLUB, AS A SECOND PRIZE IN THE TWO-FOR-ONE RAFFLE.  WHAT SAY YOU TO THIS IDEA AL? ROBERTO
On Dec 23, 2015, at 12:23 PM, Al Klase wrote:

> Folks,
> 
> The people in the New Jersey Antique Radio Club freaked out over these devices.
> http://www.ebay.com/itm/221961865013?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
> 
> The bare circuit card really needs some protection to survive long in the shop.  This template should help in making a box for it.
> 
> See attached: Should be close enough.
> 
> Merry Christmas,
> Al
> 
> -- 
> Al Klase – N3FRQ
> Jersey City, NJ
> http://www.skywaves.ar88.net/
> 
> 
> <Component tester template.pdf>______________________________________________________________
> MRCA mailing list
> Home: http://mailman.qth.net/mailman/listinfo/mrca
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:MRCA at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html