[MRCA] GRC-9 DY-88 Help request

[Steve Gajkowski]

Thanks Al, that is very close, much closer than the manual.  They state in
the manual that the values aren't to be trusted.  

 

Steve

 

  _____  

From: MRCA [mailto:mrca-bounces at mailman.qth.net] On Behalf Of Al Klase
Sent: Monday, November 10, 2014 1:07 PM
To: mrca at mailman.qth.net
Subject: Re: [MRCA] GRC-9 DY-88 Help request

 

Steve,

388.9 - 108.4 - 16.7

I do hope this is good news.

Al 



Al Klase - N3FRQ
Jersey City, NJ
http://www.skywaves.ar88.net/
 

On 11/10/2014 12:43 PM, Steve Gajkowski wrote:

 

Anyone have their DY88 open and can pull Relay K202.   I would like to
validate the coil resistance between Pin 1-9, 1-8 and 1-7.
The values in the manual are not close to what I see and in taking the coil
apart, applied a little too much heat and had the 9 pin socket completely
disconnect,  Anyway, want to make sure I have the coil properly wired as
well as seeing if the coil impedance is even close to what is required.
 
Thanks for reading and great if you are able to provide an answer.
 
 
Steve, kd3ht






______________________________________________________________
MRCA mailing list
Home: http://mailman.qth.net/mailman/listinfo/mrca
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:MRCA at mailman.qth.net
 
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/mrca/attachments/20141110/7130dfd2/attachment.html>