[Motorola] 800Mhz Maxtrac

[tvsjr]

Did you save the alignment values, or did you complete a full realignment
after you blanked the board?

When you blank the board, all of the softpots get nuked as well. You must
complete a full realignment, per Motorola procedure, to ensure the radio is
operating properly, not causing unintentional interference, etc.

> -----Original Message-----
> From: motorola-bounces at mailman.qth.net [mailto:motorola-
> bounces at mailman.qth.net] On Behalf Of jerry.tannhauser at us.army.mil
> Sent: Friday, December 15, 2006 8:31 PM
> To: motorola *
> Subject: [Motorola] 800Mhz Maxtrac
> 
> Hello all,
> 
> I am looking for help with a 800 mhz Maxtrac.
> 
> I started the conversion from a trunking radio to a conventional radio.
> So far it is not working to good.I installed a convention code plug,
> blanked the board and created a new radio profile.
> 
> Programmed it for a simplex frequency with DPL.
> 
> The receiver works OK,but no transmit.
> 
> Any help is appreciated.
> 
> The radio was going to be donated to a local state park.
> 
> Rgds,
> 
> Jerry T.
> WA6AVR
> 
> 
> Jerry Tannhauser,
> CW4 (Ret)
> U.S.Army
> ______________________________________________________________
> Motorola mailing list
> Home: http://mailman.qth.net/mailman/listinfo/motorola
> Help: http://mailman.qth.net/faq.htm
> Post: mailto:Motorola at mailman.qth.net