[Motorola] MSR2000

Tue, 1 Apr 2003 20:54:33 -0500

Doug,

I want to add 2 wire remote control consoles to an existing 4 wire SCADA
on the MSR 2000 base station. 

I don't think that an MSR 2000 has a separate line driver module,  does
it?   I'm familiar with the Line Driver card used in Micor and that is
probably what you are referring to?

On Tue, 01 Apr 2003 19:29:31 -0600 Doug Eaton <[email protected]>
writes:
> Bill,
> 
> Just Parallel the Transmit and Receive Wirelines and use it as two 
> wire. You
> should cut the Jumnper on the 1200 ohn backload resistor of the 
> transmit
> line. Then jumper the Line driver to mute thed receiver audio on 
> transmit.
> 
> If this isn't enough info, email back direct and I'll get out manual 
> and
> give you exact jumper numbers etc...
> 
> Doug Eaton <[email protected]>
> Douglas Technologies <www.dougtech.com>
> 
> PS: If yopu don't have a manual,
> 
> > From: William F Morphy <[email protected]>
> > Reply-To: [email protected]
> > Date: Sun, 30 Mar 2003 21:25:30 -0500
> > To: [email protected]
> > Subject: [Motorola] MSR2000
> > 
> > Does anybody know if an option can be added to an MSR2000 to use 2 
> wire
> > remote control audio ?
> > 
> > Or is there an aftermarket hybrid to go from 2 remote control 
> consoles
> > circuits to the 4 wire interface of the MSR2000?
> > 
> > Bill Morphy
> > [email protected]
> 
> _______________________________________________
> Motorola mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/motorola
> 

Bill Morphy
[email protected]

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com