[Motorola] MAXAR 80 help

Sat, 25 May 2002 11:40:05 -0400

Do you have any parts for a maxar80? I am in need of a coil and slug for l20
or 210 I can not remember right now which one, but it is located on the
power connector side and is the coils closest to the power connector.

Also anyone know of a source for the pre amp for a maxar80?

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Dave Marshall
Sent: Friday, May 24, 2002 5:22 PM
To: [email protected]
Subject: Re: [Motorola] MAXAR 80 help

Jack,
For the internal speaker to work, pins 9 and 12 need to be jumpered on
the power connector.  Some versions (4 freq radios) did not have an
internal speaker because that's where the channel switch and crystal
board mounted.  An external speaker needs to be connected between pin 12
and ground.  As for the mic, I have several boxes of Motorola mics.
I'll have to look and let you know.
Dave
W7MBH

Jack Hart wrote:

> I need the pinouts for the connector on the
> rear of a lowband MAXAR 80. I have a cable, but
> there is no speaker audio and I think there should
> be a jumper on the connector.
>
> I could also use a microphone...it has a
> 5-pin connector...not the normal Motorola type.
>
> Any help would be appreciated.
>
> 73,
> Jack WA2HWJ
>
> _______________________________________________
> Motorola mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/motorola

_______________________________________________
Motorola mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/motorola