[Motorola] Mitrek Mobile Setup Questions

Sun, 10 Feb 2002 16:55:37 -0800

Try this link...

http://www.repeater-builder.com/rbtip/

Or this:

http://www.batlabs.com/

Good luck
Jim W7RY

----- Original Message -----
From: Paul Cavnar <[email protected]>
To: <[email protected]>
Sent: Sunday, February 10, 2002 15:58
Subject: Re: [Motorola] Mitrek Mobile Setup Questions

| Hi John -
|
| I don't have the information at hand but, there is a neat little web
| page that shows the tune-up procedure. It is at:
| http://www.qsl.net/sra/mitrektx.gif
|
| The receiver tune up page is at:
| http://www.qsl.net/sra/mitrekrx.gif
|
| Hope this helps.
|
| Paul - NN7B
|
| ----- Original Message -----
| From: "John Flint" <[email protected]>
| To: "Motorola Listserv" <[email protected]>
| Sent: Sunday, February 10, 2002 3:48 PM
| Subject: [Motorola] Mitrek Mobile Setup Questions
|
|
| I have a couple of questions regarding a high band, high power Mitrek
| (T83JJA3900BK) that I am putting into service.  Unfortunately, I only
| have an older low power manual.
|
| First question:  Setting the output power - There are two pots on the
| main board; R909 (orange, power set) and R911 (blue, max power).  I
| presume these operate as on the low power TX.  Is the yellow  pot on the
| PA is also related to these adjustments?  What is the procedure for
| setting all three pots?
|
| Second question:  PL board jumpers - This is a HLN4181APR PL board.
| Need the functions of the following jumpers.
|
| JU1 out
| JU2 out
| JU3 in
| JU4 in "and" squelch??
| JU5 out "or" squelch??
| JU6 out
| JU7 out
| JU8 in
|
|
| Thanks in advance, reply direct.
|
| John R. Flint
| KA�LDB
|
| _______________________________________________
| Motorola mailing list
| [email protected]
| http://mailman.qth.net/mailman/listinfo/motorola
|
|
| _______________________________________________
| Motorola mailing list
| [email protected]
| http://mailman.qth.net/mailman/listinfo/motorola