[Mobile-Portable] Transmission hump mount?

[Jay]

Earl,

http://www.kenselectronics.com/lists/cbmount.htm

Click the banner at the top for the home page - he's a "CB" dealer, but I've
had good luck getting some somewhat rare mic plugs, as well as a number of
"generic" brackets for mobiles.

On the page where this link takes you, near the bottom, are some "hump"
mounts.  On my F-150 (wide flat hump) I used a B-2030.  Looks like an HUM-1
or a KSHM would have worked in most of the old cars I've dealt with over the
years with a curved top hump.  And then there's WEP-DS78B - two cup holders
and a place for a speaker, and mount your radio on top on the angled portion
of the top above the speaker.  A friend of mine did that on the floor of his
van.  His only complaint was he should have gotten a B-2030 to put more
"angle" on it - the radio didn't tip back enough for the driver to see it
with the "tall" seats in the van.

73,
Jay
AD5PE

-----Original Message-----
From: mobile-portable-bounces at mailman.qth.net
[mailto:mobile-portable-bounces at mailman.qth.net] On Behalf Of Earl Needham
Sent: Friday, December 08, 2006 00:40
To: Mobile-Portable Reflector
Subject: [Mobile-Portable] Transmission hump mount?


         Does anybody still make a transmission hump mount?  I have an older
car that I would like one for.

         Thanks,
         Earl

KD5XB
Clovis, New Mexico DM84jk
http://groups.yahoo.com/group/cw_bugs


----
Your Moderator: Dick Flanagan K7VC, mobile-portable-owner at mailman.qth.net