That would be both audio out and final. Try a mosfet like rcx081n20 for those jobs. Not an RF transistor, but good enough for 80 meters.

I think they use a zener diode in the drain circuit for the low voltage small signal fets.

I did a r391 in fets. The only thing that was problematic was the AGC control. The conversion was easier because the b+ is only 24v.

On Sunday, August 30, 2026, 3:06 AM, Hubert Miller via Milsurplus <[email protected]> wrote:

Yes, i was aware of FETRONS. Don’t think i have any schematics, tho. There were also FETRONS to replace valves

in some Telco eqpt, but i never saw any such in the years i worked there. I think HP audio generator or voltmeter or

some such. They have to be circuit specific, i think, because they need to drop the B+ from around 100 – 200 volts

to 12 to 24.

I think i have a book on the ‘Command Sets’ that shows the conversion; also i think CQ or 73 mag had an article.

But the transmitter is harder, or should i say, more challenging. I would like to keep the original working voltage

so no need to tap the output RF coil or add another audio xfmr to drive the modulation xfmr. Got to think about

that some more. Like i said, the fellow who sold the 2 converted BC-611 did not care to share his work. Maybe, i’m

guessing, it was too bone-headed and he didn’t want to admit that. Like a straight 1:1 conversion and the same

simple JFET all the way thru.

-Hue

______________________________________________________________
Milsurplus mailing list
Home: http://mailman.qth.net/mailman/listinfo/milsurplus
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html