One downside to the "make a strong mechanical connection before soldering" is that sometimes equipment makes it through testing and quality control with unsoldered joints that later prove to be a problem for the customers/users.
A tight mechanical connection allows the device to function for testing and initial deployment but after a little time (plus movement and metal oxidation), the joint stops conducting reliably. I've have found unsoldered joints in equipment that failed some time after installation. Clearly the person responsible for soldering at the factory missed that connection, but it worked OK for testing and my initial operation of the unit and only failed later.
There would be less chance of this particular failure mode if the connection was just a tack or a simple hook rather than a tightly twisted mechanical joint.
Consider that bazillions of PC board connections have been considered perfectly fine for reliability. Through-hole connections offer a bit of mechanical support, and surface mount components might have a drop of glue - but the solder connection is doing most of the work.
I am not arguing against making a tight mechanical connection, just offering this observation. And I admit I might be justifying my many tacked or hooked connections over the years.
--------------------------------------------------------------------
Radio is your best entertainment value.
--------------------------------------------------------------------
Mein Ohr ganz nah am Weltempfänger...