Is anybody out there using a Lambda  NLS3000-24, 125 amp 24VDC power supply to run stuff?  I can't find any useful info about its operation on the net, have tried to email a couple companies that sell/service them with no luck.  There are 3 pots on the side, unlabelled either inside or out, and one of them adjusts the current knee point.  I think mine is set lower than it should be, it can be set to 105% of current draw.  Its output is sagging under a dynamotor startup  load, and recovers and handles the normal load just fine.  Does anybody have a manual or know what those 3 pots do?  The voltage adjust part is clearly marked and adjustable from the front.

Charlie, W4MEC in NC