[Milsurplus] Dynamotor Power Supply.

[Jim Whartenby]

Series connecting two 12 volt switchers sounds a bit easier.  Anyone know of any issues with series connecting them?  600 watt 12 volt (50 amp) switchers running from 125 vac are available on Ebay for $13 each with free shipping.
If you delay start one switcher would you get an automatic step-start function?Jim I wonder why people argue over the 10% of their differences and ignore the 90% they agree on?

      From: David Stinson <arc5 at ix.netcom.com>
 To: 'David Stinson' <arc5 at ix.netcom.com>; boatanchors at mailman.qth.net; milsurplus at mailman.qth.net 
 Sent: Sunday, September 9, 2018 2:45 PM
 Subject: Re: [Milsurplus] Dynamotor Power Supply.
   
> I have one of those I bought several years ago 
> on eBay but have not yet used.  What is the load
> sharing connection that is required 
> to double the two outputs up?
> 73 de Mac, K2GKK/5

Here is a technical sheet on the Astec MVP
supplies:
http://www.farnell.com/datasheets/13491.pdf
https://www.artesyn.com/power/assets/mp1_revc_1192
808420_install.pdf

on the end of each module is a 10-pin ribbon cable

connector.  Set the output voltage of each module
as 
closely as possible to the same voltage, then
connect
pin 8 on each connector together.  This will cause
the
power supplies to load-share.



______________________________________________________________
Milsurplus mailing list
Home: http://mailman.qth.net/mailman/listinfo/milsurplus
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Milsurplus at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html


   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/milsurplus/attachments/20180909/072fc9c9/attachment-0001.html>