[Milsurplus] 1MC system and B+ problem

[Al Klase]

Rob,

Do you have a Megger to do a proper HV test on the transformers before 
you pull them?  I might have something you can borrow.

Al

On 4/3/2010 6:20 AM, Rob Flory wrote:
> I had the thrill yesterday of sounding the general alarm on the WWII-vintage 1MC system aboard MASSACHUSETTS.  500W from 4 push-pull, parallel 838s.  "This is just a test, DANG DANG DANG....."
>
> Rather annoying problem with a second PA unit that we were trying to get running again.  After isolating a leaky filter cap and everything downstream from the rectifier, we were still blowing fuses when we put the B+ on.  We could run the HV transformer alone, disconnected from the 866A rectifiers or even with either side of the transformer connected, but with both sides of the transformer connected to the rectifiers we got a lot of current as indicated by bright purple flash in the rectifiers before the HV primary fuse blew.
>
> We suspect an arc in the rectifier filament transformer, which shows no sign of leakage from the rectifier winding to the case or any of the other windings under test with an ohmmmeter.
>
> The next step is to try replacing the filament transformer, which also runs the 838s, with a seperate winding for each 838 filament.  Weighing in at something like 50lb and located just above the deck, this is what we call fun.
>
> Anyone have any other suggestions?
>
> RF
> ______________________________________________________________
> Milsurplus mailing list
> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>    

-- 
Al Klase - N3FRQ
Jersey City, NJ
http://www.skywaves.ar88.net/