[Milsurplus] RE: R-390-A Engraved Panels

[Dan Arney]

Here is your chance to get your 390-A panel "ENGRAVED".
The project is to have the panel CNC engraved using a end mill 
pantagraph program to engrave the furnished "FLAT" panel.
If I can get orders or 30 panels in a short period of time, like 2 weeks.
I can provide the following service in a batch order: Strip panel, 
clean, powder coat, silk screen rear of panel, engrave, fill with 
acrylic white, pack, and ship in lower 48 for $155.00. Other areas as 
per postal/UPS charges.
All panels must be flat with no tags or hardware, if required to run 
through a time-saver to get flat for engraving process $15.00 per panel.
All panels will be marked as per customers name by stamped number in the 
contact strip on the back of the panel which is masked in the powder 
process. Color is as close as original as possible.

For the economy side without recourse as to quality /depth and detail of 
engraving, your panel painted or stripped bent etc. one pass no refunds 
$80.00 no bitching. PERIOD.

This process requires a lot of  coordination, time and effort to get the 
programming correct plus all of the other related effort.

I do not need nor do I want to hear comments about the pricing. If you 
do not like it then get off of your B--- and try it on your self.

Estimate about 3 weeks for turnaround time.

Payment Payapl/Bidpay or your good personal check. Paypal in my email 
address and my shop address is:
Dan Arney
c/o Global PAck & Mail
21315-R Saticoy St.
Canoga Park, CA 91304-5685

PUT UP OR SHUT UP HiHi

Thanks es 73
Hank
KN6DI