AW: [Meteor-Scatter] YAESU FT736/R Separating RX/TX line ????

Tue, 23 Apr 2002 06:29:58 +0200

Hello,

I have done it at a friends one, but it was not typical, since that one =
had the Mutek kit installed...

The RX line can be split between the RX/TX relay and the RX board. I =
got SMA female mounted to the heat sink and a small hole drilled =
besides which fits a small coax. Then I soldered a small piece of coax =
directly after the relay, fed that through the drill, and on the other =
end an SMA goes into the female connector. From this female connector =
the line continous to the RX board. While connected, the radio behaves =
like the usual one. When you want to operate with external antenna, =
just connect iit to the the female SMA.

The same methode is shown on my web page for the FT847, see =
http://www.qsl.net/dl4mea

73, Guenter, DL4MEA

> -----Urspr> =FCngliche Nachricht-----
> Von:	ic8fax [SMTP:[email protected]]
> Gesendet am:	Montag, 22. April 2002 11:57
> An:	[email protected]
> Betreff:	[Meteor-Scatter] YAESU FT736/R Separating RX/TX line ????
>=20
> Hello all,
>=20
> I want to seperate the TX/RX lines on the YAESU FT 736/R. Does =
anybody made
> this allready ??
>=20
> Would be great to receive some info for doing it.
>=20
> Best regards de Jacob IC8FAX
>=20
>=20
>=20
>=20
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> ---
> _______________________________________________
> Meteor-Scatter mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/meteor-scatter