[Lowfer] Lowfer JH
John Hamer
wilbur0611 at gmail.com
Fri Nov 13 09:49:32 EST 2020
Hey Jim,
Thanks for the report. I haven't been to the transmitter for 2 days from
all the rain. It's good to see it's still working.
Regards
John Hamer
Lowfer JH 181.818KHz
On Fri, Nov 13, 2020, 7:16 AM Jim Davey <k8rz at etcmail.com> wrote:
> Hi John:
>
> Caught bits and pieces last night in EL87. Part of a J and a nice solid H
> around 5am.
>
> https://www.dropbox.com/s/fvd5d8zszph7pbv/Nov12_JH.gif?dl=0 <
> https://www.dropbox.com/s/fvd5d8zszph7pbv/Nov12_JH.gif?dl=0>
>
> Jim K8RZ
>
> On Nov 8, 2020, at 8:03 AM, John Hamer <wilbur0611 at gmail.com> wrote:
>
> Hey Jim,
>
> Thanks for looking. Ill check my connections and tuning today. Hopefully
> the weather will cooperate.
>
> Regards
> John Hamer
>
> On Sun, Nov 8, 2020, 7:45 AM Jim Davey <k8rz at etcmail.com> wrote:
>
> > FB John. I’ll listen for you for a few nights from southern FL, distance
> > 510 miles. I’ve copied SIW and WM here, so it should not be that
> > difficult.
> > Nothing last night, however. Caribbean storms have not quieted down
> > enough.
> >
> > Jim Davey K8RZ
> >
> > On Nov 7, 2020, at 7:43 PM, John Hamer <wilbur0611 at gmail.com> wrote:
> >
> > I setup Lowfer JH this evening. Everything is the same as last year for
> > now. 181.818khz qrss 60 1W. Transmitting from Conway, sc. Reports
> welcomed!
> >
> > My local grabber is below:
> > http://jwhamer.me/grabber/
> >
> > Regards,
> > John Hamer
> >
> > On Sat, Nov 7, 2020, 8:51 AM JJ via Lowfer <lowfer at mailman.qth.net>
> wrote:
> >
> >> OK, I jumped on the bandwagon. It's been a while since I did any Lowfer
> >> listening so it was good to fire things up.
> >> I tried yesterday late afternoon using my Anan Angelia SDR and 300' or
> >> so vertical loop situated E/W. Nada. I did finally copy after
> >> nightfall. I believe it was at t: 480.
> >> Tried again this morning with the same setup, nada.
> >> I fed my 200' Doublet fed with 300 ohm ladder directly to the Angelia
> >> and received TAG @ t. 288 but maybe a fragment at t. 192.
> >> Thank you, John for proving the signal. Good job.
> >> 73,
> >> Jon WS1K
> >>
> >> 2020-11-07 13:23:33 >WOLF10 -r 8000 -f 800 -t 1.0 -w 0.0000
> >> t: 24 f:-0.997 a:-1.3 dp: 57.8 ci:12 cj:239 . /WROS6W153LO0 ?
> >> t: 48 f: 0.088 a:-0.2 dp: 55.5 ci:12 cj:343 SSR2UF*LC8WJIEB ?
> >> t: 96 f:-0.048 a: 1.2 dp: 51.4 ci:13 cj:100 JE/H96THQMV QG. -
> >> t: 192 f: 0.332 pm:2.026 jm:755 q: -5.0 -6.6 JZEIV0S6MND ME ?
> >> t: 288 f: 0.332 pm:3.136 jm:755 q: -3.4 -5.6 TAG RAYMOND ME -
> >> t: 384 f: 0.332 pm:3.949 jm:755 q: -2.3 -3.2 TAG RAYMOND ME -
> >> t: 480 f: 0.332 pm:5.980 jm:755 q: -1.7 -1.7 TAG RAYMOND ME -
> >> t: 576 f: 0.332 pm:7.129 jm:755 q: -0.4 -0.3 TAG RAYMOND ME -
> >> t: 672 f: 0.332 pm:7.934 jm:755 q: 0.2 0.4 TAG RAYMOND ME -
> >> t: 768 f: 0.332 pm:9.279 jm:755 q: 0.9 0.7 TAG RAYMOND ME -
> >> t: 864 f: 0.332 pm:9.851 jm:755 q: 1.4 1.2 TAG RAYMOND ME -
> >>
> >>
> >>
> >>
> >>
> >> On 10/24/2020 3:23 PM, John Andrews wrote:
> >>> Lowfer TAG on 185.800 kHz from Raymond, ME is on the air in WOLF mode.
> >>> I may need to play with it some more, but it should basically be on
> >>> the air for the winter (unless Mother Nature intervenes).
> >>>
> >>> Good news/bad news: The WOLF part of the equation appears to be
> >>> running solidly, with the transmitter within 0.01 Hz of 185.800, and
> >>> the keying timing is close to perfect. The bad news is that I gave up
> >>> some efficiency by using #12 wire for the loop antenna. If this new
> >>> setup survives the winter, I will try putting up the old RG-8 next
> >>> year, and using the shield as the antenna conductor. That stuff is
> >>> pretty heavy, and the big pine that holds up one corner is right on
> >>> the lake edge, and sways a lot in the breezes.
> >>>
> >>> My guess is that this will be a dead-of-winter thing for those outside
> >>> of New England, but radio is full of surprises. Reports are always
> >>> welcome.
> >>>
> >>> For those new to WOLF, the program remains available at:
> >>> https://www.qsl.net/d/dl4yhf/wolf/index.html
> >>> I can offer advice on determining your actual receiver frequency and
> >>> your computer's sound-card sampling rate. For the folks who were
> >>> successful with EbNaut, this ought to be duck soup.
> >>>
> >>> John, W1TAG
> >>
> >> ______________________________________________________________
> >> Lowfer mailing list
> >> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> >> Help: http://mailman.qth.net/mmfaq.htm
> >> Post: mailto:Lowfer at mailman.qth.net
> >> Post must be less than 50KB total for message plus attachment!
> >>
> >> This list hosted by: http://www.qsl.net
> >> Please help support this email list: http://www.qsl.net/donate.html
> > ______________________________________________________________
> > Lowfer mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/lowfer
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Lowfer at mailman.qth.net
> > Post must be less than 50KB total for message plus attachment!
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> >
> > ______________________________________________________________
> > Lowfer mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/lowfer
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Lowfer at mailman.qth.net
> > Post must be less than 50KB total for message plus attachment!
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
More information about the Lowfer
mailing list