[Lowfer] DFCW test results

[N1BUG]

Thanks to all who ran grabbers and sent screen shots during last
night's test. This was an experiment to see how the little amplifier
would hold up at 200+ watts output under higher duty cycle and to
see whether my CW ID would be visible on grabbers.

The amplifier did fine. Efficiency was down a little this morning
because a big drop in temperature overnight drastically lowered the
antenna system resistance. I didn't bother going outside to change
taps on the transformer.

I did not see any evidence of the CW ID even on grabbers where my
signal was quite strong. Next time I run this test I will reduce the
speed of the ID to see what happens.

I am behind on email. I need to get a little sleep now so I will
remain behind a bit longer. :)

When I wake up I plan to make a few changes to the transmit
converter. If successful, I hope to be QRV for JT9-1 and JT9-2 QSOs
for the next few nights. No promises yet. If not successful the
worst result could be a ded FET and a fuse. That's about $1.50 cost
plus 20 minutes to repair, so I'm not worried about it... ;-)

73,
Paul N1BUG