[Lowfer] Hifers at EM68

[Mitch Powell]

Thanks Mike: Haven't seen a capture of the Hifer signal for quite some
time, and nice to know it is still radiating. Using single Epson programmed
chip, low pass filter and then directly to antenna. Somewhere about 75
milliwatts. dipole antenna about 10 feet high in tree !
Mitch ' M P " EN92ix

On Mon, Jan 5, 2015 at 4:20 PM, N8OOU <n8oou at meekfarm.us> wrote:

> I setup for captures today on the hifer band. As I was setting up between
> 12:00 and 13:00 UTC I audibly copied the letter "A" twice about 1 minute
> apart. The same thing was heard yesterday, at about the same time. I didn't
> have argo running, and set it to capture 13555.7 for the morning. nothing
> else was heard or seen.
>
> About 14:00 utc a very ragged square wave appeared on 13555.6. You can see
> that capture on dropbox here:
> ==> https://www.dropbox.com/s/odeihfowje9kwb0/ken135550008.jpg?dl=0
>
> By 15:06 the pattern cleared up a lot, but was still not a clean square
> wave. Could that have been NC?
>
> Tuned down to 13555.4 after lunch and found only MP and USC. A full screen
> capture is on Dropbox and the small version is attached.
>
> https://www.dropbox.com/s/rfdw5y8py9eph4i/ken135550058.jpg?dl=0
>
> Equipment used was the Kenwood TS-480, and multiband trap vertical.
> --
> 73   de   N8OOU - Mike Meek
>
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>