[Lowfer] 10 MHz OCXO for W1TAG sound card calibrator

[Paul Cianciolo]

Gentlemen,

Thank you all for purchasing the OCXOs   I have more of the units but will list them in a few days.

I need 24 hrs for each unit to tune it and guarantee it is within spec.  There was quite a run on these tonight, and I will need a few days to complete the orders
Thank you again

paulc at snet.net
W1VLF

 

________________________________
 From: Laurence KL7 L <hellozerohellozero at hotmail.com>
To: "lowfer at mailman.qth.net" <lowfer at mailman.qth.net> 
Sent: Saturday, February 15, 2014 10:53 PM
Subject: Re: [Lowfer] 10 MHz OCXO for W1TAG sound card calibrator
  

Dog team turned up and Datum 10 MHz OXCO arrived from Paul on the same day as Dexs' - not sure what their feeding those dogs.. -  only complaint is it appears to have a small (apt) Map of Texas on the PCB print :-) Very nice unit

Laurence KL7L Wasilla Palmer Alaska
Snowing -15C

From: hellozerohellozero at hotmail.com
To: dexter.mc at gmail.com
Subject: RE: [Lowfer] 10 MHz OCXO for W1TAG sound card calibrator
Date: Sat, 15 Feb 2014 15:05:19 -0900




awaiting mine Dex :-)


> Date: Sat, 15 Feb 2014 19:03:43 -0500
> From: dexter.mc at gmail.com
> To: lowfer at mailman.qth.net
> Subject: Re: [Lowfer] 10 MHz OCXO for W1TAG sound card calibrator
> 
> I received the 10 MHz OCXO from Paul today.  From a cold start, 
> approximately 65F, it took only 3 minutes for the oven to warm up and 
> start regulating.   The initial 12 volt current was only 500 ma and went 
> down to about 150 ma after warm up.  With one channel of a dual trace 
> scope triggered by 10 MHz from the GPS locked output of a HP Z3801 the 
> OCXO trace on a second channel was barely creeping after the 3 minute 
> warm up.  I tweaked the OCXO trace dead on with the Z3801 and after 
> several hours it has not moved.
> 
> Dex                              
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
> 
> This list hosted by: http://www.qsl.net/
> Please help support this email list: http://www.qsl.net/donate.html
                                                     
______________________________________________________________
Lowfer mailing list
Home: http://mailman.qth.net/mailman/listinfo/lowfer
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Lowfer at mailman.qth.net
Post must be less than 50KB total for message plus attachment!

This list hosted by: http://www.qsl.net/
Please help support this email list: http://www.qsl.net/donate.html