[Lowfer] WE2XGR/2 in Jason mode 506.5 kHz

[pbunn]

That is not likely since the sound card in and out is transformer isolated and the dame system works well with ARGO, WSPR and its derivatives as well as many other digital programs

Since JASON is and old program and Windows 7 has some problems with older 32 bit software and since the waterfall display did not work properly (it did not respond to frequency changes) and when the interface system worked very well with ARGO running at the same time as a test........  I do not think I was jumping at conclusions by suggesting Windows 7 was a possibility. ARGO was only run at the same time as JASON as a test .

Not sure what the problem was but I am confident it was not a ground loop problem with my cables.


Pat
N4LTA

Cliff Sojourner <cls at employees.org> wrote:


On 2013-01-06 17:35, pbunn wrote:
> When I back the audio off to near zero I get many parallel lines. Tuning the radio does not move them side to side. I set the maximum signal frequency readout and it does not move when the radio is tuned. It always areas around 800 HZ no matter where the radio is tuned. Looks like a Windows problem.

easy to say it's a windows problem but perhaps it's really a 60Hz +
cable problem?

Cliff  K6CLS  CM87
______________________________________________________________
Lowfer mailing list
Home: http://mailman.qth.net/mailman/listinfo/lowfer
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Lowfer at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html