[Lowfer] WD2XNS in WOLF mode

[pbunn at patbunn.com]

I have you on the screen now but no decoding/. The cal routine does not seem 
to work with Win 7. When I input the audio signal, it asked for the 
displayed value on the wolf screen, but you can't see that value because the 
cal screen covers it and I can't figure out how to see the value that needs 
to be input. Also locked up about 4 times.

Pat
N4LTA



-----Original Message----- 
From: jrusgrove at comcast.net
Sent: Saturday, February 16, 2013 2:41 PM
To: lowfer at mailman.qth.net
Subject: [Lowfer] WD2XNS in WOLF mode

WD2XNS will be transmitting in WOLF mode for the next couple hours on 
136.800 kHz. Power level will
be adjusted up and down and will be indicated in the message.

The GUI version of the decoder can be found at 
http://www.qsl.net/d/dl4yhf/wolf/index.html . Be
advised that this mode is more critical than most in terms of sound card 
calibration. There is a cal
routine in the software if you have a known frequency source.

Reports are appreciated.

Jay W1VD  WD2XNS  WE2XGR/2

______________________________________________________________
Lowfer mailing list
Home: http://mailman.qth.net/mailman/listinfo/lowfer
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Lowfer at mailman.qth.net
Post must be less than 50KB total for message plus attachment!

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html