[Lowfer] WE2XGR/2 WOLF mid day groundwave test - DIAL SETTINGS

[Andy - KU4XR]

Doug:
 
The transmitted BW is 10 Hz... WOLF has a " Pre-Filter that is 20 Hz wide if you want to use it... 
The signal is transmitted in USB... I find the CW mode the easiest to use, since my Kenwood uses 
USB for CW receive... just " set it, and forget it " that is once the sampling rate of the sound card
is set...When an operator transmits WOLF; they will usually give you the " center frequency of the signal "
In CW mode I have an offset of 550 Hz, so I set my dial to 506.50 KHz, and in the WOLF Config menu;
I set the receive center frequency to 550 Hz, and I'm up and running...
 
Hope this is useful... Any questions, feel free to call, or email me...
 
73 for now :

Andy - KU4XR - EM75xr - Friendsville, TN. USA
Coordinates: N: 35º 43' 54" - W: 84º 3' 16"
http://lwca.org/grabbers/ku4xr/
http://www.myspace.com/beaconxr
http://ku4xr.webs.com
http://lwca.org/community/YaBB.pl


----- Original Message -----
From: Douglas D. Williams <kb4oer at gmail.com>
To: "Discussion of the Lowfer (US, European, &amp, UK) and MedFer bands" <lowfer at mailman.qth.net>
Cc: 
Sent: Sunday, February 5, 2012 12:43 PM
Subject: Re: [Lowfer] WE2XGR/2 WOLF mid day groundwave test

So....should my receiver be set to USB, LSB, or CW (with the dial tuned to
506.5 kHz? What bandwith IF filters should I use?

**
D. KB4OER