[Lowfer] XJM QRSS 137.781

[John Andrews]

Eric,

Spectrum Laboratory's Digimode Terminal does it nicely.

Looking good here in central MA.

John, W1TAG

On 12/16/2012 8:38 PM, Eric Tichansky wrote:
> Though I forgot about audio generated CW for sub-hertz resolution....
> currently using QRS4.08 with rig in CW mode.  Is there any audio based
> QRSS transmission software?
>
> On 12/16/2012 20:33, Eric Tichansky wrote:
>> If 137781.605 is close enough to 137781.500, that works for me!  I am
>> using the same exciter/upconverter/100W amp setup as 600M.  The
>> exciter is a K3, so I only have 1Hz tuning steps, and the upconverter
>> LO is fixed/sourced from a GPS-disciplined DOXCO.
>>
>> 73 - Eric NO3M, WG2XJM
>>
>> On 12/16/2012 20:12, jrusgrove at comcast.net wrote:
>>> Eric
>>>
>>> Showing your frequency as 137781.605 to 137781.616. While there are
>>> no assigned frequencies we've tended to operate on certain
>>> frequencies over the years to aid in identification under weak signal
>>> conditions ... especially T/A work. XNS typically holds down
>>> 137781.000. If 137781.500 suits your fancy it's available ;~)
>>>
>>> Jay W1VD  WD2XNS  WE2XGR/2
>>>
>>>
>
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.455 / Virus Database: 271.1.1/5463 - Release Date: 12/15/12 19:34:00
>