[Lowfer] Using Argo

[Eric Smith]

Please remind me ... it has been a while but I now finally have my
radios going after moving again:

If I have my R-75 tuned right on a specific beacon's frequency, then
that signal will appear in Argo at the frequency of my side tone,
correct?

So if sidetone is 700 Hz, then in this scenario the beacon would
appear at 700 on the waterfall display, right?

Also, it seems like the last time I got this working I had to use the
Reverse feature (CW-R) but I can't remember why.

Thanks in advance for the help.  And as always, Thank You, Alberto, for Argo!

I have been foiled the last two nights in listening at 2200m.  The
first night I just didn't have all my hardware and software ready like
I thought.  Then last night I was all set up but found a huge local
signal sitting right where I wanted to be.  After a little looking
around I found it was the monitor for that computer!  Old style with a
picture tube.

So with that monitor out of the picture and G0MRF preamp humming, I
should be good to go tonight ..

Thanks in advance for the Argo help,
Eric KD5UWL