[Lowfer] [part15] " XR " testing a new mode tonite

[Andy - KU4XR]

That will depend on what tone frequency offset you like to use. For instance; 
In CW mode on my rig, I use a 550 cycle offset, so the signal shows up at 550 Hz
on the waterfall, with a dial frequency of 185.500 KHz. That is in the narrow 
passband of my filters. Dual 500 cycle filters, and my Vectronics filter is set for
a center frequency of 550 Hz. Again, on my TS450S, if I use USB, and want to
use my narrow filters, the center frequency is at 1500 Hz ( cycles ), so I set my
dial at 184.000 KHz - USB, and the signal will be at 1500 on the waterfall.
Just use 185.500 KHz( center frequency ), then add or subtract your desired 
Tone offset that you normally use. For an 800 cycle tone in USB, the dial should
be at: 185.500 - .800 = 184.700 KHz, and the signal will show at 800 on the
waterfall.

Andy - KU4XR - EM75xr - Friendsville, TN. USA
LOWfer Beacon " XR " @ 185.29875 KHz ( QRSS-60 )
Coordinates: N: 35º 43' 54" - W: 84º 3' 16"
http://www.myspace.com/beaconxr
http://webpages.charter.net/ku4xr/

--- On Sun, 5/9/10, Charlie , W5COV <cvest at cox.net> wrote:


From: Charlie , W5COV <cvest at cox.net>
Subject: Re: [part15] " XR " testing a new mode tonite
To: part15 at yahoogroups.com, lowfer at mailman.qth.net
Date: Sunday, May 9, 2010, 4:30 PM


  




Andy , this is my first time using this program and this mode .
 
I have it setup for DOMINO-EX at 4 baud .
 
Is the dial frequency for this mode 185.500 in USB ?
 
Charlie , W5COV
__._,_.___

Reply to sender | Reply to group | Reply via web post | Start a New Topic Messages in this topic (2) 
Recent Activity: 

Visit Your Group 

MARKETPLACE


Stay on top of your group activity without leaving the page you're on - Get the Yahoo! Toolbar now.



Get great advice about dogs and cats. Visit the Dog & Cat Answers Center.



Hobbies & Activities Zone: Find others who share your passions! Explore new interests.
 
Switch to: Text-Only, Daily Digest • Unsubscribe • Terms of Use


. 

__,_._,___