[Lowfer] watering hole last night

[Douglas D. Williams]

Yes, I was aware of that, but the reason I don't do it is because I
would have to go into the Argo calibration screen every time I changed
frequency (which is often), and I'm just too lazy for that, so I
calibrate my Argo screen with my CW pitch on the R75, which happens to
be 700Hz (so 700Hz on my Argo screen is always the frequency I am
tuned to). ;-)

73,
Doug KB4OER

On Thu, Dec 9, 2010 at 7:06 AM, Garry Hess <k3siw at sbcglobal.net> wrote:
> Doug, glad to hear SIW is still getting out. Thanks for looking.
> Incidentally, in case you might not know you can make ARGO display the
> actual frequency via Setup -> Calibration and entering your receiver
> dial frequency in Hz in the Offset box. For example, if your receiver is
> set to USB, 184.6 kHz then a 700 Hz audio tone will correspond to 185.3
> kHz and the ARGO frequency axis will display 185300 instead of 700.
>
> 73, Garry, K3SIW, EN52ta, Elgin, IL
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>