[Lowfer] XGR/3 WSPR Test tonight

[Richard Goodman]

John,

   I don't know if you follow "N8FQ's MEPT Discussion Page" (link below)

	http://www.electroblog.com/drsked/index.html

   I mentioned to a friend near York, PA. that you were running WSPR on 507
KHz. He copied you and posted it on this discussion board. Turns out you're
also being copied down in North Carolina.

73
Dick, WA3USG
Mechanicsburg, PA.


-----Original Message-----
From: lowfer-bounces at mailman.qth.net
[mailto:lowfer-bounces at mailman.qth.net]On Behalf Of John Andrews
Sent: Monday, March 31, 2008 4:52 PM
To: Discussion of the Lowfer (US, European, & UK) and MedFer bands;
600MRG
Subject: [Lowfer] XGR/3 WSPR Test tonight


I'm going to try something a little different tonight. XGR/3 will have
two WSPR signals, 150 watts on 508.500 and 15 watts (-10 dB) on 508.550
kHz. The same callsign (W1TAG) will be in both, but the higher power
signal will ID with 52 dBm and the other with 42 dBm. If you set your
receiver for 507.000 kHz USB, both signals will be in the passband, one
at 1500 Hz, and the other at 1550 Hz. As fading occurs, it will be
interesting to see if the signals track each other. Reports are welcome.

This should be ready by 2300 UTC...unless I run out of clipleads.

John Andrews, W1TAG / WE2XGR/3
_______________________________________________
>From the Lowfer mailing list
Send messages to: Lowfer at mailman.qth.net
To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer