[Lowfer] WE2XGR/2 WSPR

[jrusgrove at comcast.net]

Scott

Will let it run until at least 0200Z. Thanks for the look.

Jay


----- Original Message ----- 
From: "Scott Tilley" <sthed475 at telus.net>
To: "Discussion of the Lowfer (US, European, &amp; UK) and MedFer bands" <lowfer at mailman.qth.net>
Sent: Monday, December 22, 2008 8:12 PM
Subject: Re: [Lowfer] WE2XGR/2 WSPR


> Jay
> 
> I'm looking so let her run.
> 
> Scott
> VE7TIL
> 
> jrusgrove at comcast.net wrote:
>>
>> JA
>>
>> I switched over to the GUI version from the command line version at 
>> 0024. The command line version has always worked fine in the past. Not 
>> sure what's up with that.
>>
>> JR
>>
>> ----- Original Message ----- From: "John Andrews" <w1tag at w1tag.com>
>> To: "Discussion of the Lowfer (US, European, &amp; UK) and MedFer 
>> bands" <lowfer at mailman.qth.net>
>> Sent: Monday, December 22, 2008 7:52 PM
>> Subject: Re: [Lowfer] WE2XGR/2 WSPR
>>
>>
>>> Jay,
>>>
>>>> I'm easily copying your signal with a lousy antenna. But I'm getting 
>>>> a (BadMsg)instead of the usual grid square + dBm. Is this a setup 
>>>> problem on my end?
>>>
>>> The copy cleaned up at 0024Z. Now getting the full message.
>>>
>>> JA
>>> _______________________________________________
>>>> From the Lowfer mailing list
>>> Send messages to: Lowfer at mailman.qth.net
>>> To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer 
>>
>> _______________________________________________
>>> From the Lowfer mailing list
>> Send messages to: Lowfer at mailman.qth.net
>> To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer
>>
> _______________________________________________
>>From the Lowfer mailing list
> Send messages to: Lowfer at mailman.qth.net
> To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer