[Lowfer] WD2XES PSK01

Sat, 24 Apr 2004 23:58:40 -0400

John

More than solid in CT as expected. Just ran an interesting test on your
signal.

In the receiving setup here I have a laboratory step attenuator between
the output of the amplified 100' shielded RX loop and the receiver. In
the winter I normally run 10 dB of attenuation to keep the noise floor
at about 0.5 uV  and 20+ dB is required in the summer - tonight it is
about 15 dB. Was able to crank the attenuation up to 65 dB and still
receive your PSK01!

Jay

----- Original Message ----- 
From: "John Andrews" <[email protected]>
To: <[email protected]>
Sent: Saturday, April 24, 2004 6:00 PM
Subject: [Lowfer] WD2XES PSK01

> WD2XES is sending PSK01 tonight on 137.728 kHz. Use Spectrum Lab Ver.
2.4 b1
> or later to decode. The xmit frequency is GPS-locked, and you will
need to
> be within 1 Hz on the receiving side.
>
> John Andrews, W1TAG/WD2XES
> WD2XES Status: http://webpages.charter.net/w1tag/
>
>
> _______________________________________________
> From the Lowfer mailing list
> Send messages to: [email protected]
> To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer