[Lowfer] Z3801A Freq standard

[LarryP WB3ANQ]

Mike Staines wrote:

>Hi, all...
>
>Raised my 160 meter antenna about 20 feet into the air and lost wm and vd.
>Guess since the antenna was receiving them well while just lying on the lawn
>I must have been picking up the ground wave  8-)
>
>Now to the subject... While exploring cheap frequency standards I came
>across the site:
>
>http://www.endruntechnologies.com/frequency-standard-lowcost.htm
>
>
>which purports to use cell phone CDMA control signals to generate 1 pps and
>10M pps signals.
>
>I'm googling the subject but does anyone have a site that shows how to get
>the same data by hacking a cell phone?
>
>I would like to use the 10M pps signal to generate signals for my LF
>exciter. A GPS is out as my QTH is in a steep valley with limited view of
>the sky.
>
>Thanks,
>Mike
>wm1ke
>
>_______________________________________________
>>From the Lowfer mailing list
>Send messages to: Lowfer@mailman.qth.net
>To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer
>
>  
>
Mike,

Have you looked at the Z3801A / Z3816A GPS Frequency Standard?
I  have had one of these in service for over a year without any problems.
There are a few others on this group that have them also.

http://www.realhamradio.com/GPS_Frequency_Standard.htm

-- 

Larry Putman WB3ANQ FM19rc
Pasadena, MD.