[Lowfer] MedFer CO in OR

Wed, 5 Nov 2003 22:49:02 -0600

Your tracking signal is right where mine is; about 1.5 to 2hz lower than
displayed frequency. I was going to use mine as an exciter for a beacon.
Lyle drafted up an interface to key the HP for QRSS or CW.

Mike>WE0H

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Dale Rice
Sent: Wednesday, November 05, 2003 10:39 PM
To: [email protected]
Subject: Re: [Lowfer] MedFer CO in OR

The dim line at 1850 is the HP signal.
 I would like to know how to turn it off, but I have found it pretty handy
as a marker. I think pulling the internal link to the rear panel BNC
attenuates it quite a bit. It would be nice if the amplitude was adjustable.
I tuned the HP 10HZ low to look for your signal which is why it shows up at
1860.

Dale R

> That line looks like an HP tracking signal. How do you turn it off on a
> 3586C???
>
> Mike>WE0H
>
>
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]
> On Behalf Of [email protected]
> Sent: Wednesday, November 05, 2003 10:18 PM
> To: [email protected]
> Subject: Re: [Lowfer] MedFer CO in OR
>
> Hi Dale,
>   Thaks for your captures.  Glad I'm right on frequency.  What is the line
> right below CO?   Lyle also sent me a good capture from MN.  He was the
> only one to capture my Lowfer beacon last winter.
> Doug W0AH
>
>
> > I didn't believe it at first, but after several screens and being
> > precisely on 1704.800, I think this is it. (My first MedFer capture).
> >
> > http://www.orecal.com/argo/USACO00003.jpg
> > http://www.orecal.com/argo/USACO00005.jpg
> > http://www.orecal.com/argo/USACO00006.jpg
> >
> > Dale Rice
> > Williams, Oregon
 _______________________________________________

 _______________________________________________

 _______________________________________________
 _______________________________________________