[Lowfer] 6-piece BNC

Tue, 20 May 2003 17:42:31 -0500

I believe the braid is cut to 3/8th inch at well as OJ the cable 3/8th inch.
Now hold it next to the connector housing and see how long the center
conductor needs to be so the pin is flush with the end of the housing. Strip
the center insulation the appropriate length and solder or crimp it on. I'll
have a look at a search engine to see if I can find a nice picture. Try
www.amp.com.

Mike>WE0H
http://www.we0h.us/lf

-----Original Message-----
From: [email protected] [mailto:[email protected]]On
Behalf Of Eric Smith
Sent: Tuesday, May 20, 2003 5:31 PM
To: [email protected]
Subject: [Lowfer] 6-piece BNC

I have some 6-piece solder-type BNC connectors I want to put on a length
of RG-58 I have to run from my exciter (indoors) to the amp (outside).

That's the good news.

The bad news is...I don't know how to put these things together!

They are just like the one in the last picture at the bottom of this page:
http://www.aimelectronics.com/productcatalog/aimbnc7b.htm

Can you give me some help?

Thanks,
Eric, KD5UWL