[Lowfer] How can I move my Selective Voltmeter .5 Hertz? For DFCW

Sat, 15 Feb 2003 23:55:12 -0500

Ralph,

Do you know the process for inputing memories into the unit?
I do not know how to do it.

That would get me started any way

PaulC
W1VLF

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Ralph Hartwell
Sent: Saturday, February 15, 2003 8:56 PM
To: [email protected]
Subject: RE: [Lowfer] How can I move my Selective Voltmeter .5 Hertz?
For DFCW

> I am using a HP 3586C Selective Level Meter locked to 10
> Mhz GPS  as the
> source/driver for beacon USA.

<snip>

> The unit HPIB capable, and I do have the interface card,
> but do not know
> anything about programming it or what else might be needed.
> There was a gentleman on the reflector that kindly offered
> his services to
> help out in this regard,  John Hoopes but I don't if he is
> still around.

Same here, and I also would love to be able to computer control the
HP. Hopefully someone will have some answers.  I was thinking of
possibly programming two memories with the appropriate settings and
then switch between the memories, or arrange a mechanical lash-up to
move an arm attached to the tuning knob with a suitably shaped cam to
make the frequency change.

Ralph  W5JGV  WC2XSR/13

_______________________________________________
>From the Lowfer mailing list
Send messages to: [email protected]
To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer