[Lowfer] Pix of new 7' shielded loop

[Dale Parfitt]

Peter Barick wrote:

> Nice work, Dale.
>
> That's a good use for that CATV plumbing too. The first pic left me
> grinning as to the mechanics and not seeing any top support of the line.
> However, a later pic showed the support pole, a must have for integrity
> in the winds.
>
> You indicate planning raising it. It would be interesting to test sig
> levels at ground level and same sigs while elevated. If doing so, please
> report on such and how high it was raised. Can you tell us about that
> amp? Will it be replaced with one of Mitch's?

Will do Peter- I am interested too. It will be done in quick fashion so
propagation changes do not enter into the mix.\
The current amp is stock Burhans with the IN/OUT transformers changed to
bifilar FT50-75 and the AM trap omitted. I have no b'cast staions for many
many miles. One of Mitch's boards will be plugged in also though, if for no
other reason than to satisfy myself that increasing the freq response of the
amp did not hurt the low end response.

Dale W4OP